fbpx

Carrier gas furnace error code 12

Carrier gas furnace0 comments

Carrier gas furnace error code 12

Carrier gas furnace error code 12 is an error code that can be found when the burner unit of a furnace malfunction. This is a very common issue in older furnaces.

This paper aims to provide information on Carrier Gas Furnace Error Code 12, its causes and possible solutions to how it can be fixed.

Carrier Gas Furnace Error Code 12 is caused by problems with the burner unit in the furnace. Blocked vent lines, loose or broken parts around the burner, and dirty burners cause the most common ones. When this happens, gas leaks from these faults and builds up pressure inside the system, eventually blowing off one of these faulty components like a flue or combustion chamber (the ceramic part at the top).

Carrier Gas Furnace Error Code 12 could also happen because the control panel is misreading codes sent by sensors on some furnaces that run on natural gas. If your furnace has sensors, it will send its status.

Carrier gas furnace error code 12 is a common code on the Carrier furnace models. The following are the fixed codes related to Carrier gas furnaces:

I. 1611 – Starter relay contact switch is open or bad

II. 1612 – Furnace thermostat control contact switch is open or bad

III. 1613 – Furnace igniter control contact switch is open or bad

IV. 1614 – Furnace blower and fan motor control contact switch is open or bad

V. 06002 – Control system voltage too low

Carrier gas furnace error code 12 is one of the most common errors for a Carrier Gas Furnace. It usually indicates a problem with the igniting system or that the pilot light needs to be lit.

You can also check out our article on carrier gas furnace error code 12 to learn more about this issue.

 

“Inspections, Installations, Repairs & Maintenance”