fbpx

Carrier infinity furnace error code 42

Carrier gas0 comments

Carrier infinity furnace error code 42

Carrier infinity furnace error code 42 is when the Carrier infinity furnace reaches a temperature below 0 degrees Fahrenheit.

Carrier is a top-ranking heating and cooling brand that has been around for over 100 years. They offer furnaces, boilers, and air conditioning units to maintain their high standard of quality.

If you are experiencing an error code 42 with your Carrier infinity furnace, check out the troubleshooting guide provided by Carrier to see if they can help you fix it.

Carrier infinity furnace error code 42 is a series of numbers displayed on the screen when the furnace does not find any gas. The number 42 symbolizes death in Hebrew, and some Christians refer to it as “the end of times.”

The Carrier infinity furnace error code 42 means that the system will shut down for safety reasons. There are many reasons why it does so, but usually, it’s because you’re using too much gas and the system isn’t functioning properly. If this happens, your only option is to call a reliable HVAC expert.

Carrier infinity furnace error code 42 can also happen if there’s water on the clothes dryer; it will display an error code when it shuts down because of condensation dripping into the machine.

Carrier infinity furnace error code 42 is a very common error for many Carrier infinity furnaces. They can happen when the temperature control unit does not work properly or has some other mechanical malfunction.

If you’ve been getting this error code, the first thing to do is to ensure that your thermostat is working properly. If it’s not, then follow these steps:

1) Check the blower motor and motor drives. Clean them with compressed air or scale remover before replacing them if they are dirty.

2) Check the control board for any loose wires or connectors, and replace them if necessary.

3) If necessary, gently disassemble the furnace and check for any burned-out components or other problems. Make sure all screws are tightened after each step to prevent future problems with loose parts in your furnace

 

“Inspections, Installations, Repairs & Maintenance”